Intergacing R305 FingerPrint Module with 8051 MicroController
Discussion in "New Ideas regarding projects" started by vvs Feb 4, 2018.
Sun Feb 04 2018, 11:08 am
Can anyone please help me out how to Interface an R305 FingerPrint Module with 8051 MicroController
Mon Feb 05 2018, 03:31 am
You can connect the TX/RX pins of the R305 to the TX/RX pins of the 8051
if both run at the same voltage.
Load the finger prints from a PC, using a USB/ serial converter.
Use a fairly simple program on the 8051 to ask the R305 to report matches.
if both run at the same voltage.
Load the finger prints from a PC, using a USB/ serial converter.
Use a fairly simple program on the 8051 to ask the R305 to report matches.
[ Edited Mon Feb 05 2018, 03:33 am ]
Powered by e107 Forum System
Jasonkam
Mon May 06 2024, 10:00 pm
JamesroW
Mon May 06 2024, 09:37 am
Chrispes
Mon May 06 2024, 07:34 am
ArktiTic
Sun May 05 2024, 07:06 pm
CesslasyNear
Sun May 05 2024, 02:58 pm
chimichmedic1204
Sun May 05 2024, 11:06 am
Jamiegob
Sun May 05 2024, 10:11 am
Gregoryjed
Sun May 05 2024, 10:02 am